TOAD MEDICAL CORP

775 849 0244

301 Hot Springs Road #5

Carson City NV 89706


jbsoleinnovations@gmail.com

​​SOLE INNOVATIONS

Performance   Health   Healing




Custom AFO Specialists

​Complete DME Distributers

The World's First 100% Foot Off-Loading Device!

Manufactured by

SOLE INNOVATIONS

​Copyright © 2013 Toad Medical Corporation. All Rights Reserved. ​​​​

  PARTNERS & INTERNATIONAL DISTRIBUTERS 

TOAD MEDICAL CORPORATION

Used as wrapping for fractures where single layers conform to shape of limb or body

Elasticity allows for swelling without discomfort

Dressing for vein ligations, plastic surgery procedures, and burns

Available in synthetic (polyester) or cotton. 2”, 3”, 4”, 6”, 8

Type your paragraph here.Available in both cotton and polyester

Provided in 2”, 3”, 4” and 6” rolls

Great Conformability and slick resin

The Performance weave construction allows for greater movement and stretching of the material

Heat Clean fabric which minimizes running of loose ends

Extremely strong crush strength with nice clean edges.  Available in 2”-5” with colors; white, red, black, green, pink, lt. blue, dk. blue, and purple 

The yellow buffer strip, with a channel along its outside, provides safe “guard rails” for cutting the cast off. It runs along the dorsal side of the foot and lower leg, from the knee to the toes. 


Available by the yard.

Toad has all the essentials to help make casting your patient successful.  We offer cotton stockinette, casting tape in a wide variety of colors and sizes as well as plaster casting tape and cut strip.    paragraph here.

   Instructions for Casting Leg for Custom Toad Anti-Gravity Foot Brace™

The cast is essentially a long lower leg cast without padding. Patient should be sitting or lying down so there is no pressure on the calf. First place stockinette over the leg. Apply 1 or 2 layers of fiberglass or plaster casting material from middle of patella to the toes. Mark the patellar tendon, distal patella, fibular head, medial and lateral malleoli and any areas of ulceration or concern with a permanent marker. Split one or both sides of the cast with sheers or saw and remove cast. Label with patients name and allow it to fully harden. The cast is then ready to be sent in for custom brace fabrication. Make sure to pack the cast so that it can’t be crushed during shipping.